Remote Telescope Observatory - Adding Flip Cover
-
- 中子星
- 文章: 1090
- 註冊時間: 週一 11 8月, 2003 16:10
Remote Telescope Observatory - Adding Flip Cover
Adding a high resolution 6M cooled and very low noise Sky Camera inside Observatory.
- 附加檔案
-
- Sky Camera
- 20131027am-IC410+Orion-Print Screen.jpg (488.15 KiB) 已瀏覽 9693 次
最後由 HK.Raymond.Tse 於 週三 26 7月, 2017 01:53 編輯,總共編輯了 1 次。
-
- 中子星
- 文章: 1090
- 註冊時間: 週一 11 8月, 2003 16:10
The lens is full frame Canon EF 8-15mm F4 circular/rectanlinear Fisheye.扒飯撈麵 寫:which camera is used?qhy8?cctv camera lens used?
is any problem for the camera don't cover the whole sky?
The camera is QHY8, as ahown in Nebulosity2.
The whole setup is put on top of tripod and placed slightly below the telescope so that I can monitor where the scope is pointing.
The lens can be put higher up for wider FOV but the scope's accesssible FOV is enough for the time being.
-
- 中子星
- 文章: 1090
- 註冊時間: 週一 11 8月, 2003 16:10
Re: Remote Telescope Observatory - Adding Flip Cover
Designing and adding a flip-up cover for C925HD.
An add-on adapter with flip cover have been placed on top of C925HD.
Then, the perimeter of the flip cover is surrounded by rubber guard to make it more moisture/air tight.
Next step is to connect the motor for remote operation to flip-up and down the cover. Hope that the torque of the motor shaft should be strong enough to raise & hold up the metal cover plate up in the air.
Raymond Tse
An add-on adapter with flip cover have been placed on top of C925HD.
Then, the perimeter of the flip cover is surrounded by rubber guard to make it more moisture/air tight.
Next step is to connect the motor for remote operation to flip-up and down the cover. Hope that the torque of the motor shaft should be strong enough to raise & hold up the metal cover plate up in the air.
Raymond Tse
- 附加檔案
-
- 20170723 C925 Flip Cover + Rubber Guard.jpg (195.96 KiB) 已瀏覽 5847 次
誰在線上
正在瀏覽這個版面的使用者:沒有註冊會員 和 17 位訪客